HEIDENHAIN QUADRA-CHEK 2000 Demo, User Manual

Page: 52 / 92

Quick Start | Conducting a measurement
5
52
HEIDENHAIN | QUADRA-CHEK 2000 Demo | User's Manual | 06/2018
Constructing the zero point
The zero point is constructed from the point of intersection between the alignment
and the straight line.
Select
Zero point
in the geometry palette
Select the
Alignment
and
Line
features in the Inspector or in
the features view
The selected features are displayed in green
A new feature with the selected geometry is displayed
Tap
Finish
in the new feature
The zero point is created
The workpiece coordinate system for the measured object
has been determined
Tap
Features preview
The coordinate system is shown in the workspace
Figure 16: Workspace with zero point displayed in the coordinate system