HEIDENHAIN GAGE-CHEK 2000 Series, Operating Instructions Manual

Page: 97 / 236

Commissioning | Configuring the axes
Adjusting an existing table of supporting points
After a table of supporting points for segmented linear error compensation has
been created, this table can then be modified as needed.
Tap
Settings
in the main menu
Tap Axes
Select the axis
Open in the sequence
Error compensation
Segmented linear error compensation (SLEC)
Use the ON/OFF slide switch to deactivate the
Compensation function
Tap
Table of supporting points
The table lists the supporting point positions (P) and the
compensation values (D)
of the individual segments
Adjust the compensation value (D) for the supporting points
Confirm the entries with
RET
To switch to the previous display, tap Back
Activate Compensation with the ON/OFF slide switch
The adjusted error compensation for the axis is applied
Further information:
"Segmented linear error compensation (SLEC)", Page 203
Configuring the
Nonlinear error compensation (NLEC)
For a
Nonlinear error compensation (NLEC)
the measuring range is divided into
a grid of identically sized surface segments using up to 99 supporting points. For
each of the surface segments, a specific compensation factor is determined by
comparing nominal and actual values (the measured values) at the supporting
points.
The following options are available for measuring the nominal and actual values of
the supporting points:
Acquiring nominal values
Read deviations from the calibration standard (ACF)
Create a table of supporting points manually
7
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 08/2020
97