HEIDENHAIN GAGE-CHEK 2000 Series, Operating Instructions Manual

Page: 165 / 236

Measuring | Conducting a measurement
9.2.8 Displaying the diameter
Precondition: The
Diameter/Radius
function is configured
Further information: "Configuring the Diameter/Radius function", Page 133
1
2
Figure 32:
Measure
menu with activated
D/R
function
1
The diameter symbol indicates that the conversion of the position value for the
axis is active
2
Function element with active
D/R
function
The
Diameter/Radius
function allows you to double position values in the position
display. With radial axes, you can thus switch between the radius and diameter.
You can activate and deactivate the conversion by tapping the
D/R function
element in the Inspector. When you configure the function element, you can
define which axes will be affected by the conversion.
Tap Measure in the main menu
In order to display the diameter, tap the
D/R
function element
The green lettering of the function element indicates that the
D/R function is active
The product doubles the position values of the selected axes
For the axes whose position value is converted, the diameter
symbol appears
In order to display the radius, tap the
D/R
function element
again
This conversion is deactivated for all axes
9
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 08/2020
165