HEIDENHAIN GAGE-CHEK 2000 Series, Operating Instructions Manual

Page: 141 / 236

Setup | Single steps for setup
Deleting presets
In the Inspector, tap Presets
The Presets dialog appears
Tap
Edit preset table
The Preset table dialog box appears
The entries in the preset table can be locked to
prevent accidental modification or deletion. So you
might need to unlock an entry first in order to edit it.
If necessary, tap
Unlock
at the end of the row
The symbol changes and the entry can now be edited
To select one or more presets, tap the checkbox in the
relevant row
The active checkbox is highlighted in green
Tap
Delete
A message appears
Close the message with
OK
The selected preset(s) is/are deleted from the preset table
Tap
Close
The Preset table dialog box is closed
8.3.10 Configuring the measured value output
The product offers you various functions for manual or automatic transfer of the
acquired measured values to a computer.
Prerequisites:
The product must be connected to the computer via an RS-232 adapter
Receiving software is installed on the computer, e. g.
The following steps are necessary in order to configure the measured value
output:
Configuring an interface
Selecting a data format
Adding the desired function elements to the Inspector
Selecting contents for the data transfer
If you connect a USB-to-RS232 connecting cable from the manufacturer
STEINWALD datentechnik GmbH to the product, the data interface is
configured automatically and is ready immediately. The data format
Steinwald is used for measured value output. The settings are not
configurable.
8
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 08/2020
141