HEIDENHAIN GAGE-CHEK 2000 Series, Operating Instructions Manual

Page: 128 / 236

Setup | Single steps for setup
8
Configuring the network
Network settings
Contact your network administrator for the correct network settings for
configuring the product.
Requirement: The unit is connected to a network.
Further information: "Connecting a network peripheral", Page 49
Tap Settings in the main menu
Tap Interfaces
Tap Network
Tap the
X116
interface
The MAC address is detected automatically
Depending on the network environment, use the
ON/OFF
slider to activate or deactivate the DHCP function
If DHCP is active, the network settings are obtained
automatically as soon as the IP address is assigned
If DHCP is not active, enter the
IPv4 address
,
IPv4 subnet
mask and IPv4 standard gateway
Confirm the entries with
RET
Depending on the network environment, use the ON/OFF
slider to activate or deactivate the
IPv6 SLAAC
function
If IPv6 SLAAC is active, the network settings are obtained
automatically as soon as the IP address is assigned
If IPv6 SLAAC is not active, enter the
IPv6 address
,
IPv6
subnet prefix length and IPv6 standard gateway
Confirm the entires with
RET
Enter the Preferred DNS server and, if required, the
Alternative DNS server
Confirm the entires with RET
The configuration of the network connection is applied
Further information: "Network", Page 186
128
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 08/2020