HEIDENHAIN 548431-05, User Manual, Page: 671 / 722

Organization mode of operation | Transfer submode
9
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
671
Converting cycle programs
MANUALplus 4110 and MANUALplus 620 or CNC PILOT 640 have
different solutions for tool management, technology data, etc.
Also, the cycles of the MANUALplus 620 or CNC PILOT 640 have
more parameters than those of the MANUALplus 4110.
Please note the following:
Tool call
: The loading of the tool number depends on whether
the program is a multifix program (2-digit tool number) or
turret program (4-digit tool number)
2-digit tool number: The tool number is loaded as ID and
entered as the tool number T1
4-digit tool number (Tddpp): The first two digits of the tool
number (dd) are loaded as
ID and the last two (pp) as T
Approaching the tool change position : In
Tool change point
G14 , the converter enters the no axis setting. This parameter is
not used in the MANUALplus 4110
Safety clearance: The safety clearances defined in the
General
Settings parameter are entered by the converter in the Safety
clearance G47
, ...
SCI
, ...
SCK
fields
M functions are left unchanged
Calling ICP contours : When ICP contours are called, the
converter prefixes
CONV_...
to the name
Calling DIN cycles
: When a DIN cycle is called, the converter
prefixes CONV_... to the name
NOTICE
Danger of collision!
Converted NC programs may have incorrectly converted
contents (machine-dependent) or nonconvertible contents.
Danger of collision during machining!
Adapt converted NC programs to the current control
Check the NC program using the verification graphics in the
Simulation submode