HEIDENHAIN 548431-05, User Manual, Page: 466 / 722

ICP programming | Contour elements on lateral surface
6
466
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Basic elements of lateral surface
Starting point of lateral surface contour
Enter the coordinates for the starting point and target point in the
first contour element of the contour. Entering the starting point is
only possible in the first contour element. In subsequent contour
elements, the starting point results from the previous contour
element in each case.
Defining the starting point:
Press the Contour menu item
Alternative: Press the Insert element soft key
Define the starting point
Parameters for defining the starting point:
ZS : Starting point of contour
CYS
:
Starting point
of contour as linear dimension (reference:
diameter XS )
PS
:
Starting point
of contour (polar; radius)
PS : Starting point of contour (polar)
HC
:
Milling/drilling attribute
1: Contour milling
2: Pocket milling
3: Area milling
4: Deburring
5: Engraving
6: C deburring
7: deburring
14: Do not machine
QF : Cutter position
0: On the contour
1: Inside / left
2: Outside / right
HF : Direction
0: Up-cut
1: Climb
DF
:
Milling diameter
WF : Angle of chamfer
BR : Chamfer width
RB
:
Return plane
ICP generates a G110 in smart.Turn mode of operation.