HEIDENHAIN 548431-05, User Manual, Page: 123 / 722

Machine mode of operation | Machine setup
4
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
123
Setting the protection zone
With active protection zone monitoring, the control checks for
every movement whether the
protection zone in –Z direction
would be violated. If it detects such a violation, it stops the axis
movement and generates an error message.
The
Set protection zone
setup dialog shows the distance between
the machine datum and the protection zone in –ZS .
The status of the protection zone monitoring is shown in the
machine display if it has been configured by the machine
manufacturer.
Setting the protection zone and switching off the monitoring
function:
Select
Setup
Select Set protection zone
Move the tool with the axis keys or the
handwheel until it reaches the
protection zone
Use the Take over position soft key to load this
position as protection zone
Alternative: Enter the position of the protection
zone relative to the workpiece datum (
Measuring
pt. coordinate -Z field)
Use the
Save
soft key to load the entered
position as protection zone
Alternative: Switch off protection zone
monitoring
If the Set protection zone input window is open,
protection zone monitoring is inactive
In DIN programming, you deactivate protection zone
monitoring with
G60 Q1 and reactivate it with G60
Protection zone status
Protection zone monitoring active
Protection zone monitoring not active