HEIDELBERG PG.010.000B, User Manual, Page: 48 / 116

Operation
48 Version 2019
Switching on an Automatic Cutout
You must switch on an automatic cutout again after you eliminated the mal-
function that triggered this cutout. Proceed as follows:
1. Remove the right-hand side panel.
Notice
The loader turns red in the 3D display if an error occurs in the
loader. If imaging is also running parallel to that, you can run
an error correction only after imaging is finished and the
Suprasetter has switched to an error state. If you run the
error correction without waiting, imaging will be aborted, and
you may have to restart the system because of the undefined
states that result from such an action.