HEBU HBS x-touch 200i, Operating Manual, Page: 30 / 167

HBS x-touch 200i
30
EN
1 Introduction
An electrosurgical unit is a generator used to transform electronic energy into high-frequency
alternating current (HF current).
If this current flows through human tissue, it creates heat which is used for cutting and for coagulation
of the tissue.
The HBS x-touch 200i is a versatile and compact electrosurgical unit which complies to a high safety
standard and unites economy with operative flexibility.
It offers the following application modes:
For monopolar surgical use
•
Pure cut
•
Blend cut
•
Polypectomy mode
•
Monopolar cutting in moist environment (TUR)
•
Soft coagulation
•
Forced coagulation
•
Spray coagulation
•
Monopolar coagulation in moist environment (TUR)
For bipolar use:
•
Bipolar cut (Bipolar Scissors)
•
Bipolar cutting in moist environment (TUR)
•
Bipolar coagulation
(mode “Bipolar Forceps”)
•
Bipolar cutting in moist environment (TUR)
•
Bipolar coagulation
(mode “Bipolar Forceps AUTO Start”)
•
BiSeal coagulation
Benefits of the HBS x-touch 200i:

Simple, intuitive and safe operation

Current terminal for optional wireless foot switch, max. 0.5 A

Display-supported neutral electrode safety system helps interactively when applying the neutral
electrode

Nine storage locations for individual program settings

One monopolar multifunction terminal for 3-pin standard or Martin plug

Scope for input of an AutoDelay until the prescribed output is reached and an AutoStop function for
automatic interruption of the energy supply after a certain tissue resistance level is reached

Tone signal with scope for control of the volume and an alarm tone in case of faults without facility
for switching off

Coloured illumination of the LCD display in red, yellow, blue to indicate different operating modes
or error statuses

Facility for tracing output and impedance at the LCD display in the patient circuit on activation

Worldwide application possible through connection scope from 100 to 260 volts, 50 to 60 Hz