background image

HSQWPH1500N 

Quartz Weatherproof Heater 

Installation and Operating Instructions

Telephone:

0117 923 5375

Fax: 

0117 923 5374

Victoria Road, Avonmouth, Bristol BS11 9DB    

www.heatstore.co.uk

Maintenance

The heater contains no moving parts and therefore very little maintenance

is required other than to ensure that 

there is no excessive build-up of dust/dirt on the reflectors or emitters
as this can cause overheating and premature emitter failure. 

To clean the appliance, turn off and disconnect from mains supply,
allow to cool then wipe with a damp cloth.

Lamp Replacement

The lamp used in the fitting is robust and if knocks and shock vibrations are
avoided, will last for around 5000 hours.

To replace the lamp:

Disconnect the heater from the power supply by unplugging from the mains
socket and wait until the body has cooled down.

Remove both end caps by undoing the 2 socket head screws at each end.

Remove the guard and end reflectors.

Unclip the lamp from the spring clips at each end, allowing the emitter to
move forward clear of the back reflector.

Unclip the reflector from the heater casing.

Disconnect the emitter wires from the terminals located in the electrical box
on the rear of the heater, and then remove the lamp.

Insert the wires of the new lamp through the holes in the heater body to the
electrical box and reconnect them into the terminals. Ensure that the
terminals are tightened correctly to make a good electrical connection.

Re-assemble making sure all the parts are replaced and the guard is in
position 

IMPORTANT SAFEGUARDS

WHEN USING ANY ELECTRICAL APPLIANCE, BASIC SAFETY

PRECAUTIONS SHOULD ALWAYS BE FOLLOWED.

PLEASE READ ALL INSTRUCTIONS CAREFULLY 

AND RETAIN FOR FUTURE REFERENCE

IF IN ANY DOUBT ABOUT THE INSTALLATION OR USE OF THIS

PRODUCT, CONSULT A COMPETENT ELECTRICIAN.

Issue 2 0910

Waste electrical products should not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authority or
retailer for recycling advice.

Specification

HSQWPH1500N:

1500W; 230-240V ~50Hz; 6.5A

IP

55

F

HSQWPH1500N[10]instructions  7/9/10  10:46  Page 1

Reviews: