PRELIMINARY SETUP
HOW TO ATTACH 107-ESCK
CONVERSION KIT TO
107-A FRAME
Detach the electrical line cord from 107-A frame. Then, remove
the old 107-A hot plate and front plate assembly from the 107-A
frame, by removing the support rod (A) and the two self tapping
screws that fix the base of the front plate assembly to the frame.
Angle the 107-ESCK conversion kit assembly forward, so that
the electrical box switches are positioned below the console bar
(B). Lower the back of the conversion kit into position, making
sure to line up the screw holes (C) and the support bar holes
(D).
With the nylock hex nut and washer on the rod, insert support
rod through the 107-A frame, side plate assembly, then through
the conversion kit and out the other side. Attach washer and
nylock hex nut (E) to the other end of support rod.
*For older 107-A models, you may have to widen the hole in
both outer aluminum side plates (F) that the support rod must
thread through in order to align all holes.
Fasten the self taping screw through the conversion kit assem-
bly and into the 107 aluminum frame. Repeat on the opposite
side.
Attach the electrical line cord to the 107 aluminum frame with
the line cord clamps and screws included with the ESCK unit.
3
B
A
C
2
*
D
E
ESCK
4
F
Revised 20
17
5
