Heath Zenith 530882, Installation And Operating Instructions Manual

Page: 8 / 32

8 206546-02
BULB REPLACEMENT
1. Remove the two decorative screws holding the lower
arm and remove arm from fixture (see Figure 1).
2. While holding the glass assembly, remove the two
decorative screws holding the glass assembly and remove
glass from fixture (see Figure 2).
3. Replace bulb (tungsten incandescent, medium base,
type “A”, 100 watt maximum).
4. Reattach the glass assembly and lower arm reversing
the steps above.
Decorative
Screws
Decorative Screw
Lower Arm
Glass Assembly
Light Bulb
Figure 1 - Remove Lower Arm
Figure 2 - Remove Glass Assembly
Note:
When first turned on wait about 1
1
/
2
minutes for
the circuitry to calibrate.
* resets to Auto Mode at dawn.
Mode: On-Time Works: Day Night
Test 5 Seconds x x
Auto
1, 5, or 10 Minutes x
Accent 3, 6 Hour, To Dawn x
Manual
To Dawn* x
Operating Modes
• Motion Sensor (AUTO) – This light fixture is designed
to automatically turn on when the sensor detects a tem-
perature difference moving across the front of the motion
sensor. The light will turn off automatically after a set
amount of time. The ON-TIME control should be set
to 1, 5, or 10 minute setting and the wall switch should
be left in the ON position at all times.
• Optional DualBrite® Control – This optional feature
allows the light fixture to turn on at a lower light level
after dusk (sunset) for the amount of time selected. When
motion is detected, the lights will turn on full bright. This
feature can be turned OFF and the motion sensor will
continue to work in AUTO mode.
• Manual Mode – This light can be activated to stay on full
bright after dusk (sunset) for only one night at a time. It
automatically resets to motion sensing at dawn (sunrise).
Manual mode must be re-activated each night.
Note:
If
power to the light fixture is off for more than 5 seconds,
allow the electronic circuitry in the sensor to calibrate
(90 seconds) prior to switching to manual mode.
1. To turn on MANUAL mode, switch the light off at
the wall switch for 1 to 2 seconds and then back on.
2. To return to AUTO mode, switch the light off at the
wall switch for 1 to 2 seconds and then back on.
Note:
The sensor will also reset to AUTO mode at
sunrise.
Turn Switch OFF for
1 to 2 seconds
Turn Switch
Back ON