background image

Read This Before Operating

IMPORTANT

DO NOT RETURN THE POWERALLEY PRO MACHINE TO THE RETAIL STORE WHERE 

PURCHASED.  CALL TOLL FREE: (800) 492-9334.

USE POWERALLEY LITE-BALLS OR POWERALLEY Pro REAL BASEBALLS IN THE MACHINE

The PowerAlley Pro Pitching Machine uses PowerAlley Soft Lite-Balls, PowerAlley Regular Lite-Balls and 

PowerAlley Pro Real Baseballs.  Heater Sports recommends using official PowerAlley Lite-Balls or PowerAlley 

Pro Real Baseballs in the PowerAlley Pro Pitching Machine.  These balls are incredibly accurate, long lasting, 

and produce the best performance in the machine.

CUSTOMER SERVICE

HEATER SPORTS 

is dedicated to your customer satisfaction.  If you experience any trouble with the 

operation of the PowerAlley Pro Pitching Machine contact us at: (800) 492-9334 or log on to our

website at www.HeaterSports.com.

WARNING: 

THIS PRODUCT IS TO BE USED BY ADULTS ONLY.   MAKE SURE MACHINE IS TURNED OFF BEFORE 

ASSEMBLY!  KEEP HANDS AND ALL BODY PARTS AWAY FROM BALL ENTRY AND EXIT!  SERIOUS HAND, EYE, AND 

BODILY INJURY MAY OCCUR IF USED INCORRECTLY!

•  Please be sure to read all of the instructions before using the PowerAlley Pro 

 

Pitching Machine to insure the machine is working properly.

•  Parents: Your child should be made aware of the potential dangers of using the

 

PowerAlley Pro Pitching Machine.

•  Never put your fingers into the PowerAlley Pro Pitching Machine.

•  The PowerAlley Pro is not a toy and an adult should supervise children.  It is very important

 

the batter makes sure the area is clear before swinging a bat.

•  Stay clear of the ball opening while the PowerAlley Pro is operating.  Although the balls may be

 

very light, they may cause eye damage or other injury may occur.

 

Children must be advised of this danger and appropriate precautions should be taken.

• 

DO NOT 

use any type of ball other than Heater Sports Balls in this machine. 

•  Always use a NOCSE approved batting helmet when batting.
• 

DO NOT LOOK INTO THE FRONT OF THE MACHINE WHILE THE POWERALLEY PRO IS RUNNING

.

 

Occasionally a ball may get stuck in the machine.  The ball may pause and then shoot out and cause 

 

eye injury.  If the ball gets stuck, turn off the machine immediately.  You should be able to remove the 

 

ball easily by tilting the PowerAlley Pro backwards to eject the ball.

•  Never operate in water or moisture.

•  Always store in a dry area.

Summary of Contents for PowerAlley






Reviews: