14 EPU‐D Installation and Operation Manual
059840‐00 Rev. A
Heat‐Timer Corp.
Mounting the EPU‐D Module
Mounting the Enclosure
1. Select an appropriate location to mount the EPU‐D. The location must meet the following minimum
requirements:
• The mounting surface should be flat and strong enough to hold the weight of the device.
• The device can be mounted a maximum of 500 feet (152.4 meters) from the sensor location, but should
be mounted as near as possible to avoid excessive wire runs.
• DO NOT mount the device in a location where it will be exposed to extreme heat, cold, humidity, or
moisture.
2. Remove the Enclosure Wiring Cover (1) by removing the two lower screws (2) holding it to the base (3),
and then remove the Display Module (4) by removing the two middle screws (5) holding it to the base.
Figure 4:
EPU‐D Control Module Parts Diagram
1
2
3
4
5
5
