Heat & Glo • TiaraE• 4035-822 Rev F • 01/05
10
7
Maintenance and Servicing the Fireplace
A.
Cleaning Firebox and Control Compart-
ment
•
Turn the appliance off and disconnect the power cord from
the outlet.
• Allow the appliance to cool before cleaning.
• Remove the top of the appliance by grasping the top on
both sides and lifting up.
•
Remove the heater system. See Figure 7.1. Rest it on top
of the appliance so it does not fall.
• Remove
the
firebox top to access the log area.
• Replace all parts after cleaning has been completed.
• Plug in power cord.
B. Cleaning Glass Doors and Back Glass
The glass is cleaned in the factory during the assembly pro-
cess. During shipment, installation, handling, etc. the glass
surface may collect dust particles. These can be removed by
buffing lightly with a clean dry cloth.
To remove fingerprints or other marks, the glass can be
cleaned with a damp cloth using a good quality household
glass cleaner. The glass should be completely dried with a
lint free cloth or paper towel.
In the event of glass breakage, vacuum all remaining glass
pieces with a shop vac.
DO NOT VACUUM IF PIECES ARE
HOT!
Replace glass with only a glass panel ordered direct
or through your local distributor. Never use substitute mate-
rial. Only fully tempered soda lime safety glass may be used
on this appliance.
Figure 7.1
Remove the Heater System
Shock Risk
Burn Risk
Cleaning, performing maintenance or moving
this electric stove without disconnecting
power and allowing the stove to cool could
create a shock or burn hazard.
• Turn controls to “OFF”.
• Remove plug from outlet or turn off the
circuit breaker to the stove.
WARNING