HearthStone Quality Home Heating Products Inc
Tucson Model #8701
23037-1
10
Manufactured Home Construction and
Safety Standard, Title 24 CFR, Part 3280
(U.S.) or Standard for Manufactured Home
Installation, ANSI/NCBCS A225.1 or
Standard for Gas Equipped Recreational
Vehicles and mobile Housing, CSA
Z240.4.CAN/SCA Z240 MH (Canada).
(Installer l’appareil selon les codes ou
règlements locaux, ou, en l’absence de tels
règlements, selon les Codes d’installation
CAN/CGA-B149.)
For installations from 610-1370 meters
(2000-4500 ft.) the orifice sizes (DMS) for
natural and propane gas are 41 and 54
respectively. See data plate for additional
information. For high altitude installations
consult the local gas distributor or the
authority having jurisdiction for proper
rating methods. If the installer must convert
the unit to adjust for varying altitudes, the
installer must complete the information
sticker and adhered it to the appliance at the
time of conversion.
(Cet appareil est equipè
pour des altitudes compries entre 0 et 2000
pieds (0-610 m) seulement.)
I
TEMS
R
EQUIRED FOR
I
NSTALLATION
* Accessory stone set
* External regulator (for propane/L.P.G. only)
* Piping which complies with local codes
* Pipe sealant approved for use with
propane/L.P.G. (resistant to sulfur compounds)
* Manual shutoff valve
* Sediment trap (see page 24)
* Tee joint
* Pipe wrench
* Phillips head screwdriver
* 7/16-inch wrench
* Other parts as required by local code
*Safety Glasses
*Gloves
P
ACKING
L
IST
1-Tucson Gas-Fired Heater
4-Decorative Ceramic Logs
1-Bag Charcoal Embers Only
1-Bag Charcoal Embers and “Rock Wool”
1-Owner’s Manual
1-Thermostat
1-40’ Thermostat wire
1-L.P. Fuel Conversion Kit
1-Warranty Validation Form
1-Exhaust Restrictor Plate with Mounting Screw
Note: Vent kits and components are supplied
separately. Failure to use the venting
components suggested by HearthStone will
void your warranty.
U
NPACKING AND
I
NSPECTION
U
NPACK AND
I
NSPECT FOR
D
AMAGE
The Tucson is packaged by the manufacturer
to withstand shipment without damage.
However, damage can still occur during
transit; so take care to inspect for damage
when unpacking and installing the unit. If
any damage, or missing parts are detected,
immediately contact your dealer
.
Do not install, or put into service, a
damaged or incomplete heater.
Caution: The stones and top grill are
NOT cemented, or otherwise permanently
fastened in place!
We recommend your
Tucson be moved into place, venting
attached, gas and electrical connections
made, and any accessory blower installed
before installing the stone set, or top grille.
Inspect the Tucson for visible or concealed
damage. The unit should appear to be square
and true. The stone set should be whole and
without cracks, chips, or breakage. The
sheet metal parts should be smooth and free
of bends and dents. The enameled cast iron
should be free of chips or cracks. If visible
or concealed damage is found or suspected,
contact your dealer for instructions.
