background image

2081-935 Rev D 12/19/05 

Page 1 of 5

 

 
 
 

WSK-SOUL-TMR 

 

INSTALLATION AND OPERATING INSTRUCTIONS 

 

 

 
 
INTRODUCTION

 

 
Hearth & Home Technologies wireless wall mount timer system was developed to provide safe, reliable, and user-friendly remote 
control system for gas heating appliances.  The system can be operated manually from the transmitter. The system operates on one of 
65,536 security codes that are programmed into the transmitter at the factory.  
 

COMPONENTS 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

WALL TIMER 

 
 

The wall timer operates on a (2) 3V button cell batteries (included) made 
specifically for remote controls and electronic lighters.  Before using the wall 
transmitter, install the two (2) 3V button cell batteries. Follow instructions below. 

 

The wall timer has a 30 min, 60 min, 120 min, and OFF buttons. When any of the 
buttons on the wall timer is pressed, a signal light on the wall timer illuminates 
briefly to verify that a signal has been sent. If the signal light does not illuminate, 
check the batteries. Upon initial use, there may be a delay of five seconds before 
the remote receiver will respond to the wall timer.  

 

 

 

 

 

 

 

 

 

 

 

 

 

 
 
 

Note:  

In addition to these instructions read and 

follow instructions in gas appliance Owner’s Guide. 

 

WARNING

!

 

Hearth & Home Technologies disclaims any responsibility for, 
and the warranty will be voided by, the following actions. 
 

 

Installation and use of any damaged system 
component. 

 

Modification of the system component. 

 

Installation other than as instructed by Hearth & 
Home Technologies. 

 

Installation and/or use of any component part not 
approved by Hearth & Home Technologies. 

 
Any such action may cause a fire hazard. 

 
Read, understand and follow these instructions for safety and 
operation. 

TRANSMITTER

REMOTE RECEIVER

SLIDE

BUTTONS

R

E

M

O

T

E

ON

OFF

WALL-MOUNT COVERPLATE

 AA BATTERIES

2 ea.

12V (A23) Transmitter

battery(included in

transmitter)

4 ea.

HARDWARE

(2) 3V Button Cell Transmitter

batteries (included in

transmitter)

3V

3V

2 ea.

Indicator

  Light

30 MIN

60 MIN

120 MIN

OFF

REMOTE

OFF

ON

LEARN

ADJ.

 

Indicator
  Light

30 MIN

60 MIN

120 MIN

OFF

 

Reviews: