Hearth & Home Technologies • CDLS Log Placement Installation Manual • 4099-975 Rev. B • 03/21
1
Log Placement Instructions
Model: CDLS
WARNING: Turn off appliance and allow to cool com
-
pletely before beginning installation. DO NOT use this
kit with any other internal hearth option such as stones.
Kit Contents:
• Three (3) driftwood logs
• Six (6) log support pin brackets
• Six (6) #8 bracket mounting screws
NOTE:
Do not handle logs with your bare hands.
Always
wear gloves to prevent skin irritation from log material.
After handling the logs, wash your hands with soap and water
to remove any traces of fibers.
NOTE
: Prior to installing the log set, you must first install the
pin brackets on the burner. The air deflection glass and glass
media should only be installed after the pin brackets are in
Figure 1 – Log Pin Placement for AVFL42N(P)IP-BU, AVFL42N(P)IP-RB, AVFL48N(P)IP, AVFLST48N(P)IP,
ODLANAIG-48 AND ODLANAIGST-48
place. The air deflection glass should be installed prior to
placing glass media on the burner. For proper air deflection
and glass media placement, please refer to the Appliance
Owner’s and Installation Manuals. The logs must then be
placed in the unit after the glass media and air deflection
glass. If the optional logs are added to the appliance after
installation of deflective glass and glass media, move the
glass media away from the pin location holes on the firebox
bottom assembly as per Figure 1.
AVFL42N(P)IP-BU, AVFL42N(P)IP-RB, AVFL48N(P)IP,
AVFLST48N(P)IP, ODLANAIG-48 AND ODLANAIGST-48
1. Mount the four log support pin brackets using mounting
holes and screws provided in locations indicated in Fig-
ure 1 for the front and rear log. Only one hole of the pin
bracket will be used to secure the pin to the outside of the
burner assembly base. The other hole remains unused
and rests on the mesh area. Next, arrange glass media
evenly across the burner again.
For use with the following models: AVFL42N(P)IP-RB, AVFL42N(P)IP-BU, AVFL48N(P)IP, AVFLST48N(P)IP,
AVFL60N(P)IP, ODLANAIGST-48 AND ODLANAIG-60
Log Pin Locations
