1
Hearth & Home Technologies • ARCH-KIT-36, ARCH-KIT-42, ARCH-KIT-50 Instructions • 2281-939 Rev. G • 10/19
Leave this manual with party responsible for use
and operation.
NOTICE:
Proper clearances from the fireplace opening
to any finishing material thicker than one inch MUST be
maintained.
Top and side templates are included to ensure that
finishing materials thicker than one inch
do not interfere
with the installation and operation of the door. Refer to
the appliance installation manual for more information
regarding the different finishing methods.
KIT CONTENTS:
• Left and Right Arch Fill Pieces
• Top Arch Template
• Arch Strip
• Left and Right Side Finishing Templates
• Top Finishing Trim
• Left and Right Finishing Trim
• Top Glass Vanity Panels (2)
• Bottom Glass Vanity Panel (Included on Forge Front only)
• (8) 1/2 Inch Self Tapping Screws
• (4) 10-24 x 3/4 Hex Screws
ARCH FILL
PIECE (2)
LEFT AND RIGHT
SIDE TEMPLATES
TOP ARCH
TEMPLATE (1)
ARCH STRIP (1)
THREADED
INSERT (4)
NOTCH
Figure 1. Arch Kit Components
ARCH-KIT-36, ARCH-KIT-42, ARCH-KIT-50
Models: FS-36A, FS-36AIFT, FS-42A, FS-42AIFT, FS-50A, FS-50AIFT, FORGE-36A,
FORGE-36AIFT, FORGE-42A, FORGE-42AIFT, FORGE-50A, FORGE-50AIFT
Installation Instructions
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
CAUTION! Do not install damaged components.
WARNING! Risk of Fire!
Combustible materials
MUST
NOT
overlap or be placed behind a decorative front.
DANGER
HOT GLASS
WILL
CAUSE BURNS.
DO NOT TOUCH
GLASS
UNTIL COOLED.
NEVER
ALLOW CHILDREN
TO TOUCH GLASS
.
A barrier designed to reduce the risk of
burns from the hot viewing glass is provided
with this appliance and shall be installed for
the protection of children and other at-risk
individuals.
Introduction
This kit is for use with decorative fronts installed using
the inside fit finishing method. Inside fit decorative fronts
may be recessed into non-combustible finishing material
up to 4 inches thick.
Figure 2. Vanity Panels
TOP ARCH VANITY PANELS
BOTTOM VANITY PANEL
Note: Bottom vanity panel is used on Forge Arch
decorative fronts only.
