Healson Technology Co.,Ltd.
26
Warning
：
Close the software before plugging in/out the probe, otherwise it will cause faults easily.
Place the probe on a flat surface before plugging in/out the probe, in this case it will protec
the probe from falling down resulting in damage.
Caution
：
Close the software before plugging in/out the probe, otherwise it will cause faults easily.
Place the probe on a flat surface before plugging in/out the probe, in this case it will protec
the probe from falling down resulting in damage.
4.8 Connect Intelligent Terminals
Turn on the intelligent terminal, and connect USB cable. Enter the software interface by clicking
desktop icon.
Check whether there is abnormal heating when the probe is working.
Warning
：
Using abnormal probe may burn the
patient.
Follow next steps to check
：
Check image to make sure of that there is no abnormal phenomena(abnormal noise, flicker,etc).
Also check following items:
d
4.9
Diag
nosi
s
Sme
ar
ultrasound gel on the diagnostic part of patients, let the probe contact the part , then an image will
be shown on the monitor. Different tangent planes will be displayed by changing probe angle and
gradient. Select proper image as the basis of diagnosis. If gain is not good enough, adjust it to get
best image.
4.10 Restart if with faults
When following abnormal situation occur, reconnect the device by exiting/open software:
Always show error information on the screen.
Abnormal screen displaying.
No.
Item
Method
Warni
contact o
ng: If any abnormal phenomena, it means defaults. Sh
urAmbnaorkrm
etainlgsoduenpdt,, aofdtedr-fslaavleosr, doerpotv,eorrhaegaetintgsnim
otmaellodwiaetedl
ut down the system an
y. Visual/Hear
No error information
Visual
No obvious abnormal noise, discontinuously displaying
or black area in mode B
Visual
Surface of acoustic lens is not overheating(check by
hand)
By hand
No black line or interference in the image area.
Visual
