HE-VA Disc Roller 2,5m, Operating Instructions Manual

Page: 6 / 60

UK Disc-Roller 2,5 - 3,0 – 3,5 - 4,0 m (1-section) 12/08-2014
6
Safety and Instructions on Hydraulics
1.
The maximum working pressure is 225 bar.
2.
It is advisable to label the attachment parts at hydraulic connections between the tractor and the tool
in order to eliminate incorrect operation!
3.
When checking for hydraulic leaks, use suitable safety wear (eye protectors, gloves, etc.)
High-pressure hydraulic oil may penetrate the skin and cause dangerous injuries.
In case of injury, consult a doctor immediately. RISK OF INFECTION!
5.
After operating the hydraulics, lower the machine to firm ground.
Relieve the hydraulics, stop the motor and remove the ignition key.
6.
Check the hydraulic hoses on a regular basis, however, every six months as a minimum due to any
cracks, wear and tear, etc. Replace any defective hoses immediately.
The life of hydraulic hoses is maximum 5 years.
New hydraulic hoses must meet the manufacturer's requirements.
INSTRUCTIONS ON TRANSPORT ON THE PUBLIC ROADS
Check before transport on public roads that the attachment of the machine at the tractor is in accordance with
the local rules and regulations in force (permitted total weight, permitted axle load, transport width, lights,
warning signs, etc.).
FRONT AXLE LOAD
After the attachment of the machine and at maximum load, the driving properties of the tractor must
be ensured. Check that the front axle is sufficiently loaded. As a minimum, the front axle load must
be 20% of the tractor weight. Permitted axle load and permitted total weight for the tractor must
always be observed.
NB! The driving, controlling and braking properties are affected by the attached machine
combination.