HDG Turbotec 50 L, Operation Manual, Page: 80 / 100

7 Cleaning and maintaining the heating system – Procedure
80
3. Place the ash pan (4) in front of the boiler.
4. Open the combustion chamber door (3).
5. Using the supplied scraper or flat scraper, push the combustion
residue from the flame channel (1) and ash compartment (2) into
the ash pan (4).
6. Empty the combustion residue into a fireproof container.
7. Close the combustion chamber hatch (3) in the reverse sequence.
8. End the “Reload” function by pressing the Minus key.
The flame channel and the ash compartment are clean again.
C
LEANING THE HEAT EXCHANGER SURFACES
1. Allow the fire in the boiler to burn out and cool off.
Figure 7/5 - Cleaning the flame channel and ash compartment
1
3
4
2
Caution!
Make sure no ashes are left in boiler when it is not in operation, e.g.
during the summer.
Caution!
See the “General safety instructions” section in this chapter.