HDanywhere MHUB S, Quick Start Manual

Page: 7 / 21

Stacking basics
Assumptions
This guide assumes that the reader is already familiar with MHUB and HDBaseT matrix systems.
Hardware Requirements
In order to build an MHUB S stack you will need the following in your setup:
●
One or more MHUB S devices.
●
HDMI cables to connect MHUB S devices together (sold separately).
●
uControl Zone Processor 1 or 5 (ZP1/ZP5) to act as your Controller.
Ports essential to building a stack
Stacking is made possible by two ports on the rear of each MHUB S.
1. The “Mirror (OUT)” port
This port mirrors any HDMI signal connected to the “Source (IN)” port directly below it. Connecting
the “Mirror (OUT)” port to the “Source (IN)” port on another MHUB S (must be next in the Stack
Layer) will make that video available on the new MHUB S device (
see page 7 ).
2. “Stack IR (IN)” & “Stack IR (OUT)” ports
Used for MHUB S’ IR Cascading function and can be connected using the Source IR Stacking Cable
included with MHUB S ( see page 8 ). Stack IR only works with a maximum of 4 MHUB S systems.
7