HDanywhere MHUB S, Quick Start Manual

Page: 2 / 21

Stacking with a Control System
Working with a Control System is easy.
If you are using a Control System to control your MHUB S devices then you do not need a Zone Processor
to act as a controller. Connect and stack your MHUBs as per the example wiring diagrams on page 7 and
ensure that you follow the instructions detailed below.
YOU MUST INITIALISE ALL HDA DEVICES BEFORE YOUR DRIVER WILL WORK!
Control System drivers for MHUB S will not work until your device has been initialised in a process
called “First Boot”. To complete this step you will require our app,
uControl , to scan your network, find
your devices, and initialise them one-by-one.
I’m using a Control System, why should I do this?
It is important to carry out this step as it registers the Extended Warranty for the owner and connects
your MHUB(s) to HDA Cloud for improved customer support and troubleshooting analysis. This step
also instructs MHUB for third-party operation and Expanded IO (using MHUB’s IR ports directly from
your Control System) if your driver supports that feature.
Finding a Control System driver.
For an up-to-date list of supported drivers please visit the following link:
http://support.hdanywhere.com/hda-control-drivers/
2