©HBS Bolzenschweiss-Systeme GmbH & Co. KG
All rights reserved – Reprinting, in whole or in part, only with the approval of the manufacturer
44
10 Preparing the Welding Head
Adjusting the protrusion
Insert the workpiece.
Make sure that there is a welding element in the chuck.
Use the 0/ON pushbutton to set the display to 0.00.
0.00
Move the Z-axis (in setup mode) to the working position.
The set value appears on the display as a negative value.
-2.00
Adjust the protrusion according to your welding task (e.g., protrusion =
2.5 mm).
Loosen the locking bolt for the height adjustment G.
Now use a WAF 17 socket wrench to turn the height adjustment H to
the value that is to be set.
The set value appears on the display.
-2.50
Secure the set value by again tightening the locking bolt.
Use the 0/ON pushbutton to set the display back to 0.00.
0.00
Summary of Contents for 94-31-412C
Page 61: ......