43
©HBS Bolzenschweiss-Systeme GmbH & Co. KG
All rights reserved – Reprinting, in whole or in part, only with the approval of the manufacturer
10 Preparing the Welding Head
Adjusting spring force
Move the Z-axis (in setup mode) to the home position.
Remove the rear cap.
B
Set the spring force according to your welding parameters (e.g., spring
force = 5 mm).
To do this, turn the spring-force adjustment screw B with a WAF 17
socket wrench to the value that is to be set.
The scale makes use of a vernier scale.
0.5 on the scale means: each 0.5 mm of spring force is equal to one half
turn of the adjustment screw:
Upper value
for integer places
Middle value
for decimal places
The currently applied spring force is shown on the display
for spring-force adjustment, in this example 5 mm.
0
5
10
15
Mount the rear cap.
Summary of Contents for 94-31-412C
Page 61: ......