Settings
32
A02590_04_E00_00
HBM: public
TIM40
12.1.1
System/Interface module
Displays the firmware version of your device (see also
Firmware update).
12.1.2
System/Torque transducer
Lists the main data of the connected torque measurement flange (e.g. the
nominal (rated) torque).
12.1.3
System/Default settings
You can select the menu language (Deutsch/English), assign a project name
and protect your settings with a passcode (1 to 4 digit number code). If you
activate the passcode, other users cannot change your settings, only read
them.
The zeroing and activation of the shunt is independent of the passcode.
In delivery condition, no passcode is active.
12.1.4
System/Ethernet interface
You can find your Ethernet connection data here and can switch the DHCP
Client on/off. You can select the signal and start/stop the data transmission
here.
The activation of the UDP data output without configured recipient leads to a
buffer overflow which is displayed in the status, the status display lights up red.
12.1.5
System/Fieldbus interface
This menu contains information about your fieldbus connection (CAN or PRO
FIBUS). You can set the CAN baud rate and the increments of the PDO output
rate (e.g. Increment 2
→
Measurement rate = 2.4 kHz). In addition, you can
select if and which signal (TP1/TP2) is output via PDO1.
12.1.6
System/Passcode input
After entering the correct passcode, you can change all settings.
