HBM SK12, Mounting Instructions, Page: 39 / 48

39
SK5, SK6, SK12
HBM A0842-2.0 de/en
Fig. 9.4: Brush holder SK5/ZB
25 Mounting (see safety notes)
25.1
Mounting of slipring body SK5 with brush holder SK5/ZB
1. The shaft end intended for the slipring body shall be machined to dimen-
sion as required for the inner diameter of the slipring, tolerance h6, for a
length E (see chapter 14. Dimensions).
2. Theslipring body is mountedwith alightinterferencefittotheshaft, cablessho-
wing in the direction of the transducer connections.
3. Fasten Allen screw to secure the connection.
4. The brush holders shall be arranges at opposite sides of the shaft (see fig.
10.1). This is precondition for a safe signal transmission. The brush holders
shall be mounted in such a way that the brush underneath the black clam-
ping screw is associated with the first slipring next to the cable outlet. The
clamp connections marked with colours on the brush holder will then be in
the same sequence as cable core colours of the slipring body.
5. Align the brush holders in such a manner that all brushes have full contact
with the sliprings.