Anschlüsse und Anzeigen
26
A3169-8.0
HBM: public
CX22B / CX22B-W
Modul‐LED
Die Modul‐LED (
) leuchtet
grün
, wenn die Stromversorgung des CX22B‒W vor
handen ist. Das Modul benötigt nach dem Einschalten
jedoch noch ca. 2 Minuten, bis der Bootvorgang vollstän
dig abgeschlossen ist.
LED's am Ethernet‐Anschluss
Die LED's leuchten wie folgt (siehe Nummer 3 in
Linke LED leuchtet, wenn eine Ethernet‐Verbindung
vorhanden ist und blinkt bei Netzwerkanschluss mit
10/100MBit .
Rechte LED leuchtet, wenn das Gerät mit 1GBit
arbeitet.
Status‐LEDs für den Betriebszustand
Die LED „RECORDING“
leuchtet kontinuierlich
gelb
, wenn Messdaten aufge
zeichnet werden. Falls ein Start‐Trigger festgelegt
wurde, blinkt die LED gelb, solange noch auf das Trig
gerereignis gewartet wird.
Die LED „ERROR“
leuchtet
gelb
, wenn die Software einen Fehler festge
stellt hat, z.B. wenn die Verbindung zu Geräten beim
Projektstart nicht hergestellt werden konnte. Die LED
blinkt, wenn der verfügbare freie Speicher unter
1GByte fällt.
Alle Status‐LEDs können auch über
Grenzwerte und
Ereignisse
von catman
EASY angesteuert werden.
Wählen Sie dazu
Digitalausgang setzen: CX22B Digi
talausgang
im Dialog
Grenzwert‐ und Ereignisüber