Anschlüsse und Anzeigen
22
A3169-8.0
HBM: public
CX22B / CX22B-W
4.8
Digitale Ein‐ und Ausgänge
Es stehen Ihnen 3 Eingänge an den Klemmen 1, 2 und 3
sowie 3 Ausgänge an den Klemmen 4, 5 und 6 zur Verfü
gung. Der Status der Ausgänge wird über LEDs ange
zeigt,
.
Eingänge
Der Pegel für die Eingänge ist 5Volt im offenen Zustand
(HIGH), da er über einen Pull‐up‐Widerstand auf HIGH
gezogen wird (aktiv LOW). Der maximale LOW‐Pegel für
die Eingänge beträgt 0,7Volt.
Ausgänge
Der Pegel für die Ausgänge ist 5Volt (HIGH), wenn der
entsprechende Ausgang gesetzt wird, sonst 0Volt
(LOW). Die Ein‐ und Ausgänge sind TTL‐kompatibel, die
Leitungslänge an den Ausgängen darf maximal 3m
betragen.
Tipp
Beim Start eines Messjobs werden die Ausgänge auf
LOW zurückgesetzt, wenn Sie in catman
[
EASY bei den
Optionen für den CX22B‒W (Gruppe
System
) die Ein
stellung
Bei Start eines Messjobs alle Digitalaus
gänge des CX22B‒W zurücksetzen
aktivieren.
4.9
START/STOP‐Taste
Mit der Taste START/STOP können Sie einen Messjob
starten und/oder stoppen. Verwenden Sie dazu einen
Trigger für den Start und/oder den Stopp des Messjobs