HBM Quantum X MX403B, Operating Manual

Page: 291 / 416

Safety instructions
ITC-U1001
A4749-1.0 HBM: public
5
S
The ITC-U1001 is intended solely for use in combina­
tion with a QuantumX MX809B. If the ITC-U1001 is
also integrated into a system, it is the responsibility of
the system installer to keep the system safe.
1.3 Maintenance and cleaning
Please note the following points when cleaning the ITC-
U1001:
S
Disconnect the ITC-U1001 from all current and
voltage supplies.
S
Take suitable measures to ensure that the ITC-U1001
cannot be exposed to dangerous electric potential.
S
Clean the parts of the ITC-U1001 with a soft, slightly
damp (not wet!) cloth. You should never use solvents,
since they could damage the parts of the voltage
measuring lead.
S
When cleaning, ensure that no liquid gets into the
parts of the ITC-U1001 connector.
S
Give the ITC-U1001 sufficient time to dry before
starting it up again.
1.4 Working safely
S
When unpacking the contents of the package, check
to ensure that everything is present. When it is un­
packed, the ITC-U1001 should be inspected for
mechanical damage. If damage has occurred during
transit, the voltage measuring lead must not be oper­
ated.
S
Error messages should only be acknowledged once
the cause of the error has been eradicated and there
is no further danger.