In the
Board Calibration
or
Board Verification
window:
2
Click
Set up CalStack...
to open the
CalStack Setup
window.
The
CalStack Setup
window will be displayed.
Figure 4.13:
CalStack Setup window
Ensure that:
l
The IEEE address for each component in the equipment list matches the
actual device address of that component.
And, if you are using the IOtech Serial/IEEE488:
l
The COM port of the IOtech Serial/IEEE488 controller matches the settings
of your IOtech configuration.
For details, please refer to the IOtech specifications.
3
Click
OK
to save the changes you have made to the CalStack definition.
If you want to exit the CalStack setup, click
Cancel
.
For a few seconds the ISOBE5600 Calibration and Verification software will
attempt to communicate with the instruments in the CalStack.
ISOBE5600
I2716-4.0 en
65
