Windows
®
7
-
optimum settings
IMPORTANT
To best achieve the specified 200 MB/s data transfer rating please make
sure the following settings are introduced to your network adaptor via the
settings in Windows.
Windows
®
7 10G network adapter settings:
l
Interrupt moderation rate:
high
l
Receive side scaling ques:
8
l
Receive buffers:
2048
For more information on how to do this please see appendix “Optimal Windows
settings for 10Gbit Ethernet card” in GEN series Data Acquistion manual.
Note
The above Windows settings were tested and chosen using a specific setup of
equipment (Intel
®
Ethernet Server adaptor x520). These setting may not be the
optimal settings for your specific system.
11.6.1
Installing a 1 Gbit SFP/10 Gbit SFP+ Module
Introduction
This section explains how to install and remove the Small Form Factor
Pluggable (SFP or SFP+) transceiver device from any interface that supports
SFP or SFP+ modules.
This device enables an optical network connection to be plugged directly into
the front panel, in the optical network interface of the Interface/Controller. This
option is also required in order to use the 10 Gbit Ethernet card.
Warnings
Before installing this device, please read and make sure that you have
understood the following warnings, which are specific for this device.
GEN3i
I3763-3.1 en HBM: public
197
