HBK 10M0, Mounting Instructions, Page: 20 / 106

C5
TEDS CHIPS TRANSDUCER IDENTIFICATION
18
9 TEDS CHIPS TRANSDUCER IDENTIFICATION
A TEDS (Transducer Electronic Data Sheet) chip allows you to store the rated outputs of a
sensor in a chip in accordance with IEEE 1451.4. The C5 can be delivered with TEDS chip,
which is then fitted in the transducer housing, connected and supplied with data by HBK
before delivery.
The force transducer is always delivered with a test record.
If the sensor is ordered from HBK without additional calibration, the results of the test
report will be stored in the TEDS chip. If an additional DAkkS calibration is ordered, the
results of the calibration will be stored in the TEDS chip.
The chip content can be edited and modified with suitable hardware and software. This
can be achieved with HBK’s Quantum Assistant or DAQ software, for instance. Please pay
attention to the operating manuals of these products.
Information
Please note that no characteristic values are stored for any bending moment bridges that
may be ordered.