Assembly Instructions M8146-EN
M8146-EN 2019-07
12/16
Sealing set (O/ID T27101, T27102)
1.
Carry out preparation (
page 3).
For switching module (20)
Fig. 21: Remove the cover of the switching
module
2.
Proceed as follows to disassemble the cover:
Disassemble the flexible tube of the tool circuit exit (OUT M).
Disassemble the main line temperature sensor (BT 1).
Disassemble 8x screws (label 1) and remove cover.
Fig. 22: Mount the cover of the switching
module
3.
Proceed as follows to mount the cover of the switching
module (20):
WARNING!
Damages if leaking!
The re-use of used seals can cause leaking.
Therefore:
– seals are to be compulsory replaced after each
disassembly of the cover.
WARNING!
Damages if leaking!
Leaking if torque is wrong.
Therefore:
– Tighten cover of the switching module with
37 Nm.
Remove the old seals, clean the sealing surface and place the
new seals (label 1).
Attach the cover and tighten the 8 screws with a torque of
37 Nm.
Mount main line of the temperature sensor (BT 1) at the cover.
Connect the flexible tube of the tool circuit exit (OUT M).
For buffer module (21)
Fig. 23: Remove the cover of the buffer
4.
Proceed as follows to disassemble the cover:
Disassemble flexible tube of the buffer entry (c).
Disassemble the temperature sensor of the buffer (BT 3).
Disassemble the 1 screw on the rear panel of the unit.
Disassemble 4x screws (label 2) and remove cover.
1
BT 1
1
2
BT 3
c
