Hazet 9011 MG, Operating Instructions Manual, Page: 17 / 20

17
Always wear personal protective clothing and safety equipment!
3. Operation
• Turn on the compressor to start the filling of
the air tank.
• Adjust the air compressor regulator to
90 PSI (6.3 bar). The maximum working
pressure of this tool is 90 PSI (6.3 bar).
• The rotation performance may vary depend-
ing on the size of the air compressor and on
the output volume of compressed air.
• Do not use damaged, worn-out or low-
quality air hoses or connectors.
• Do not use sockets or accessories intended
for manual use.
• Make sure to use only impact sockets of the
appropriate size.
• Push throttle lever to operate the tool.
• Turn regulator to adjust the power and
sense of rotation. Forward operation = F;
reverse operation = R.
• 9011, 9012 and 9013 MG include 3 power
settings in forward and 1 power setting in
reverse operation.
• 9012 KS and 9012 UL include 3 power
settings in forward and 2 power setting in
reverse operation.
• 9012-90 include 1 power setting in forward
and 1 power setting in reverse operation.
• 9014 MG and 9014 MG-LG include 3 power
settings in forward and 3 power setting in
reverse operation.
• Release throttle lever to stop tool opera-
tion.
• Be aware of the fact that the tool continues
moving for a while after the throttle lever has
been released.
• When the work is done, switch off com-
pressor and store it as indicated in its
operating instructions.
• Use clean and dry air at 90 PSI (6.3 bar)
maximum pressure only. Dust, combus-
tible steams and a too high moisture can
damage the motor of a pneumatic tool.
• Do not remove any stickers; replace
damaged stickers.
• Keep hands, wide clothing and long hair
away from the moving parts of the tool.
2. Prior to Operation
Pneumatic tools have to be
used, inspected and maintained
always in compliance with the
respective local, state, national
or federal regulations.
• Drain compressor tank and remove con-
densation water from the air hoses. Read
thouroughly the operating instructions of the
compressor tank, too.
IMPORTANT:
The use of an air filter and an air
hose oiler is recommended.
ATTENTION!
Before oiling, plugging in/out the
tool, disconnect the tool from the
compressed air supply.
• For oiling the tool, see chapter 4
“Maintenance and Cleaning” further on in
these operating instructions.
• Remove the dust cap at the air inlet.
• Connect the tool to a correctly sized air hose.
See table on page 16
햴
Design and Function
GB USA