www.haze
base
.com
6
English
3.4 First Steps
1.
Connect the DMX output of the fog machine via 5 -pin XLR DMX cable (I) of the base•low•pro. If your
fogger has a PowerCon connector exhibit ( max . 3 kW / 1kW for US) you can connect this to the power
output ( G ) of the base•low•pro.
2.
Connect the supplied security hose to the CO
2
bottle and connect connector ( K ) .
Safety Instructions:
Before connecting the connecting tube check whether all threads and fittings are clean. To ensure that no
CO
2
can escape uncontrolled, tighten screw with a suitable tool.
3.
Open the valve of the CO
2
bottle completely
4.
The supplied PowerCon cable to connector ( H ) plug. Is the plug rotating rightward until it snapped.
5.
Insert the plug in an sockets connection.
6.
In order for proper operation of the base•low•pro make sure that the connected fogger has programed
the DMX start address „001“.
7.
Now the base•low•pro is ready to start.
Wait until the connected fogger is fully heated. This takes about 7min at Hazebase foggers. For more informa
-
tion, please refer to the manual of your fog machine.
