®
Your Hayward Pro Series high rate sand filter is a high perfor-
mance totally corrosion-proof filter that blends superior flow
characteristics and features with ease of operation. It repre-
sents the very latest in high rate sand filter technology. It is
virtually foolproof in design and operation and when
installed, operated and maintained according to instruc-
tions, your filter with produce clear, sparkling water with
only the least attention and care.
HOW IT WORKS
Your filter uses a special filter sand to remove dirt particles
from pool water. Filter sand is loaded into the filter tank and
functions as the permanent dirt removing media. The pool
water which contains suspended dirt particles is pumped
through your piping system and is automatically directed by
the patented filter control valve to the top of the filter tank.
As the pool water is pumped though the filter sand, dirt
particles are trapped by the sand bed, and filtered out. The
cleaned pool water is returned from the bottom of the filter
tank, through the control valve and back to the pool through
the piping system. This entire sequence is continuous and
automatic and provides for total recirculation of pool water
through your filter and piping system.
After a period of time the accumulated dirt in the filter
causes a resistance to flow, and the flow diminishes. This
means it is time to clean (backwash) your filter. With the
control valve in the Backwash position, the water flow is
automatically reversed though the filter so that it is directed
to the bottom of the tank, up through the sand, flushing the
previously trapped dirt and debris out of the waste line.
Once the filter is backwashed (cleaned) of dirt, the control
valve is manually re-sequenced to Rinse, and then Filter, to
resume normal filtering.
INSTALLATION
If you own an above ground pool please see note: NSP1-4
Article V, for safe proper installation of the equipment
package.
Only simple tools (screwdriver and wrenches), plus pipe
sealant for plastic adapters, are required to install and/or
service the filter.
The filter should be placed on a level concrete slab, very
firm ground, or equivalent, as recommended by your
pool dealer. Position the filter so that the piping connec-
tions, control valve and winter drain are convenient and
accessible for operation, servicing and winterizing.
Assemble pump and pump mounting base, (if supplied)
to the filter according to instructions packed with the
base.
1.
2.
STRAIGHT ADAPTER
RETURN TO POOL
FROM
POOL
PUMP
ELBOW ADAPTER
VARI-FLO
CONTROL VALVE
SIGHT GLASS
FILTER
CLAMP
PUMP
MOUNTING
SCREW/WASHER
TYPICAL INSTALLATION
24 - 1/2” (63 cm)
WASTE LINE
38” (96 cm) S-210T
38” (96 cm) S-210TR
41” (104 cm) S-220T
42” (106 cm) S-244T
IS 210T HC 13
www.haywardpool.ca
