APPROVED:
DRAWN:
PART NUMBER
SCALE:
SHEET
OF
REVISION
DRAWING TYPE:
SIZE: A
BY:
ECN NO.
DATE:
DATE:
ECN:
REVISED PER
CHK'D.:
Haws Corporation - All Rights Reserved. HAWS and other trademarks used in these materials are the exclusive property of Haws Corporation.
C
R
MODEL(S)
1455 KLEPPE LANE
SPARKS, NEVADA 89431
(775) 359-4712 FAX (775) 359-7424
E-MAIL: [email protected]
WEBSITE: WWW.HAWSCO.COM
THIS DOCUMENT IS TRUE AND CORRECT AT TIME OF PUBLICATION. CONTINUED PRODUCT IMPROVEMENTS
MAKE SPECIFICATIONS AND MEASUREMENTS SUBJECT TO CHANGE WITHOUT NOTICE.
FV
06/28/21
1
0510001207.D
H1117.8HO/H1117.8HO2
NA
1
3
FV
06/28/21
5706
DP
INSTALLATION
5706
2021
FV
CHILD/ADULT
WASTE
ADULT
STANDING
WASTE
A
12
12
DETAIL A
(NOT SUPPLIED)
SMALL BACK
PANEL
LARGE BACK
PANEL (SUPPLIED)
SMALL BACK
PANEL
1-1/4" IPS WASTE
(NOT SUPPLIED)
1-1/4" NPT TRAP
(SUPPLIED)
2X
MTGFR.17 MOUNTING FRAME
REQUIRED - SOLD SEPARATELY
FRAME
FLANGE
WALL FACE
5
2-7/8"
[73mm]
GRILLE
ELECTRICAL
WALL
ADULT
STANDING
BUBBLER
ADULT
STANDING
FOUNTAIN
CHILD/ADULT
BUBBLER
CHILD/ADULT
FOUNTAIN
FLOOR
(4)
[10
2mm]
MOUNTING
FRAME
WIDTH
STUD
SUPPLY STOP AND
3/8" OD TUBING
12
[305mm]
CLEARANCE
4 1
4
[108mm]
36-3/16
[920mm]
[791mm]
31-1/8
*
1-3/4
[44mm]
*
*
*
*
3
CHILLER SUPPORT TRAY 12
ROUGH-IN
ROUGH-IN
*
NOTES:
1. HOLD ROUGH-IN DIMENSIONS ± 1/8" (3.2mm)
2. WHEN INSTALLING THIS UNIT, LOCAL, STATE, OR
FEDERAL CODES SHOULD BE ADHERED TO. FOR
INSTALLATION DIMENSIONS (LOCATIONS), WASTE
AND SUPPLY REQUIREMENTS OTHER THAN SHOWN,
DIMENSIONS MARKED (*) MUST BE ADJUSTED
ACCORDINGLY.
3 REFER TO MTGFR.17 INSTALLATION DRAWING FOR
FRAME ROUGH-IN DIMENSIONS.
4 REFER TO 5874 SERIES OPERATION AND
MAINTENANCE MANUAL FOR PUSH BUTTON AND
VALVE INSTALLATION/MAINTENANCE INSTRUCTIONS.
5 ROUGH-IN DIMENSIONS FOR FOUNTAIN HEIGHTS:
CHILD WHEELCHAIR HEIGHT: SEE SHEET 3 FIG 1
WASTE: 26-1/4" (667mm)
FOUNTAIN: 24" (610mm)
BUBBLER: 29-7/8" (756mm)
ADULT WHEELCHAIR HEIGHT: SEE SHEET 3 FIG 2
WASTE: 29-1/4" (743mm)
FOUNTAIN: 27" (686mm)
BUBBLER: 32-7/8" (832mm)
ADULT STANDING HEIGHT: SEE SHEET 3 FIG 3
WASTE: 34-3/4" (883mm)
FOUNTAIN: 32-1/2" (826mm)
BUBBLER: 39-3/8" (972mm)
6. REFER TO MODEL H1117.8HO/H1117.8HO2
INSTALLATION DRAWING SHEET 3 OF 3 (ON HAWS
WEBSITE WWW.HAWSCO.COM) FOR PERMISSABLE
BOWL MOUNTING PATTERNS. TWO WHEELCHAIR
HEIGHT FOUNTAINS CANNOT BE MOUNTED SIDE BY
SIDE PER ANSI A117.1
NOTES CONTINUED ON SHEET 3 OF 3
3/8" OD TUBING,
INSULATION, TEE
& FITTING
(SUPPLIED)
INLINE STRAINER,
1/4" OD TUBE X
3/8" OD TUBE
INLET (SUPPLIED)
10 3
4
[272mm]
25
[635mm]
SUPPLY
39
[991mm]
(1 7
16
)
[36mm]
[305mm]
[305mm]
1
2
[13mm]
1878
[480mm]
32
[813mm]
406mm
16"
FRAME FLANGE BUTTS AGAINST
MUST BE INSTALLED SO THAT
IMPORTANT: MOUNTING FRAME
FINISHED WALL FACE.
SENSOR
FROM CHILLER OUTLET
TO
BUBBLER
HEAD
-Vo
+Vo
AC(L)
AC(N)
BLACK WIRE
WHITE WIRE
TRANSFORMER
SENSOR WIRING / SUPPLY PLUMBING
SCHEMATIC
TO PUSH
BUTTON
FOUNTAIN
VALVE
SOLENOID
VALVE
PRESSURE
REGULATOR
2X SHEET METAL
2X MOUNTING CLIP
INSIDE OF FRAME
(SUPPLIED)
SCREW
FRAME
MOUNTING
SCREW
(SUPPLIED)
2X MACHINE
GRILL
(SUPPLIED)
B
DETAIL B
BACK
PANELS
MODEL H1117.8HO SHOWN
MODEL H1117.8HO2 ON SHEET 2
(ROUGH-IN DIMENSIONS APPLY TO BOTH MODELS WITH EXCEPTIONS NOTED ON SHEET 2)
100-277VAC-9VDC
TRANSFORMER
AND DC CABLE
(SUPPLIED)
FROM DIRECT
CONTACT WITH WATER
MUST BE PROTECTED
13
LOCATE AND INSTALL
SENSOR
EYE
ELECTRICAL
9VDC SOLENOID VALVE
TRANSFORMER 13
13
(SUPPLIED)
HCR8
CHILLER
REQUIRED -
SOLD
SEPARATELY
5
*
5
*
5
*
5
*
5
*
REGULATOR
CONNECT 3/8" PUSH-TO-CONNECT TEE
TO 3/8" X 1/4" REDUCER THEN TO 1/4"
DIAMETER OUTLET TUBE ON HCR8
3
3
WITHIN WALL
ACCESS
SURFACE
LINE
WATER CHILLER
(SUPPLIED)
4
14
15°