11
2
3
1
1
If you
choose
to connect any external
devices such as sensors, alarms, etc., you
can connect them to the I/O terminal block.
(Please refer to the user’s manual for I/O
voltages.)
3
Locate the power input connector on the
left-hand side of the rear panel of the camera
and attach the external power supply. To
ensure the camera is powered on, please
check to see that the red “Power/MIC” LED
located on the black plastic panel on the front
of the camera is lit. (To ensure a network
connection, please check to see that the green
“Activity” LED is lit or flashing.)
2
Locate the network cable connector (RJ-
45 port) on the left-hand side of the rear
panel of the camera. Connect an Ethernet
cable to the port. Connect the other end of
the cable to the network.
Please Note
: For initial setup and
configuration, you will need to use a
wired
connection. After completing the setup
and configuration, you can begin using
your network camera wirelessly.
