Hawkeye Mfg AGCO RoGator A Series, Installation Manual

Page: 45 / 54

CHAPTER
7
Sidekick Pro™ ICD Installation: Connecting Sidekick PRO ICD Direct Injection Pumps to the ISOBUS 41
CHAPTER 7
SIDEKICK PRO™ ICD
INSTALLATION
CONNECTING SIDEKICK PRO ICD DIRECT INJECTION PUMPS TO THE
ISOBUS
Sidekick Pro direct injection pumps installed by AGCO are Raven CAN version and are connected to the CANbus.
To work with the Hawkeye® 2 Product Control System, change the pumps to Sidekick Pro ICD pumps and connect
them to the machine’s ISOBUS using a Raven adapter cable (P/N 115-0172-325). Contact a local Raven dealer to
order this cable and ICD pumps if necessary.
NOTE: If adding a new injection system to the machine, also order the required AGCO cable harness from
your local AGCO dealer.
1. Inspect the Sidekick Pro label to determine if it is the ICD version. The label will either read Raven Sidekick Pro™
ICD and the part number will be one of the following:
•
P/N: 1-063-0173-768 (1-40 oz/min pump)
•
P/N: 1-063-0173-769 (5-200 oz/min pump)
FIGURE 1. Raven Sidekick Pro ICD Label
2. Remove the cover of the ECU cabinet that contains the product control ECU’s on the middle of the right frame
rail. Refer to Figure 1, “RoGator ECU Cabinet Location,” on page 25.
3. Locate the RoGator ISOBUS Tee Cable (P/N 115-0172-325). This may have been provided with your Hawkeye® 2
system kit, or it may need to be ordered.
4. Remove the 4-Pin to 3-Pin Deutsch adapter cable with ISOBUS Terminator and set aside. This will be used in a
later step.
5. Follow the cable from the injection pumps down the frame rail to the round bulkhead connector on the back of
the ECU cabinet. This is typically the bulkhead connector furthest towards the front of the machine on the ECU
cabinet.
6. Locate the mating bulkhead connector on the inside of the ECU cabinet.
7. Identify and disconnect the green/yellow twisted wires from the identified bulkhead connector that lead to a 4-
pin Deutsch connector in the ECU cabinet.
8. Connect the 4-pin Deutsch receptacle coming from the bulkhead connector to the mating 4-pin plug on the
ISOBUS adapter tee (P/N 115-0172-325) where the adapter and terminator were removed.
9. Locate and disconnect the square Raven passive terminator on the cable harness near the Sidekick Pro Injection
Pumps.