Rapid resume logic
This system will store its current state to non-volatile memory. If power is lost and then
reconnected the system will recall the stored state from memory. This means if the unit
is in armed mode and the battery disconnected for any reason, when battery is
reconnected the unit will still be in armed mode. This applies to all states of the system
including armed, disarmed etc.
Learning transmitter codes
This alarm system can support up to 4 remote controls. The included transmitter is pre-
programmed into the system memory at the factory. Follow the below steps to add or
delete a new transmitter.
1. In disarming mode, IGNITION OFF position. Turn IGNITION ON/OFF 8 times
within 2 seconds and lastly turn it ON, siren will sound once, indicating system
entered into code learning mode.
2. Press and hold (within 10 seconds) any button on the first remote for 1 second, siren
will sound for longer duration once and followed by siren sounding for short
duration. This indicates remote has been learned. The second, third and fourth
remote can be learned at the same way. After the fourth remote finished learning, the
siren will sound for long duration to indicate the system exited learning mode. Turn
IGNITION off. If the remote did not get any new codes within 10 seconds, the
system will exit learning mode automatically.
Note: once entered into code learning mode, all previously learned remotes will be cleared.
Auto alarm reminder
Interior light
When car is parked and owner left car after 10 seconds, system will sound siren 3
times and flash hazard light 3 times to remind the owner to arm the security system.
When system disarmed interior light will come on automatically for 30 seconds.
8
