Installation Instructions C-3619
MOTOROLA MW800/MW810 CPU TRUNK MOUNT
1995-2009 FORD CROWN VICTORIA
DRIVER SIDE TRUNK CPU BRACKET:
•
Remove driver side taillight.
•
Position CPU Mount bracket so holes in bracket line up w/ taillight
mounting holes.
•
Reattach taillight through holes in bracket, then loosely attach nuts.
•
Drill ¼” holes through vehicle trunk frame wall on opposite side of
bracket. Use front side of bracket as a drill guide.
•
Attach ¼-20 x ¾” Hex head bolts and ¼” Serrated nuts.
•
Tighten all hardware.
•
Mount CPU to Housing bracket using (4) 5mm-.8 x 10mm Hex
head machine screws and washers.
Be sure ON/OFF switch on
CPU is turned ON at this time.
•
This housing will be mounted to CPU Bracket after CPU cables
are attached and wiring is complete.
ATTACH CABLES TO CPU:
•
Data cable from monitor to Display 1.
•
Speaker cable box to port labeled AUX and Audio Out
•
Ignition sense cable attaches to Speaker cable box.
•
Route antenna cable to CPU
•
Attach antenna connector to antenna cable
•
Leave a service loop and wire tie antenna cable to CPU cover.
•
Now that all cable is attached and wiring is complete attach CPU
Housing to CPU bracket using pem-studs and ¼” serrated nuts
designated for the specific components.
•
CPU cables will face Rear Passenger Side taillight when mounted
then loop down and around computer, up the inner wheel well, to
the back seat wall.
•
CPU must be level, both vertically and horizontally, to meet
Motorola standards.
•
Place CPU cover (CM93625) on mount using 10-32 x ½” Machine
screw.
C-3619_INST_12-08
