Havis-Shields C-VS-1200-EXPD-1 Install Instructions Download

Page: 1 / 4

INSTALL INSTRUCTIONS C-VS-1200-EXPD-1

VEHICLE SPECIFIC CONSOLE

2007-2008 FORD EXPEDITION

(w/ Console shifter)

TOOLS REQUIRED:

Ratcheting wrench
Sockets Set
Panel pulling tool

Screwdriver set
T-20 torx bit

HARDWARE:
QTY DESCRIPTION PART

#10 x ½” Phillips machine screw

GSM33118

#10 Keps nut

GSM30028

Always

Read all instructions before installing any Havis-Shields Equipment Corp products.

Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!

Use hardware provided with install kit

For product support, visit the Install Instructions Section of our website at

http://havis.com/Installation/Installation.html

Front

#10 x ½” Machine

screws and keps nuts

Rear

C-VS-1200-EXPD-1

Summary of Contents for C-VS-1200-EXPD-1

Page 2: ...emove accessory pocket liner as shown above Remove trim panel from console Remove hex head screw from accessory pocket armrest View of panel removed Remove hex head screw from accessory pocket CAREFULLY remove trim from around gear shifter Remove trim from around the cup holders ...

Page 3: ... pocket Remove hex head screws holding lower sides accessory pocket Remove hex head screws holding side of accessory pocket Remove hex head screws holding rear of accessory pocket Remove the rear OEM cup holder Pry up on accessory pocket trim panel and remove Remove 4 hex screws holding armrest pad from hinge ...

Page 4: ...usly removed earlier Install 10 x machine screws and keps nuts as shown above View of console installed View of specific application including C TCB 24 C ARM 2 C 3090 7 control heads etc Sold Seperatly Replace hex head screw on accessory pocket Position console so holes in side of console align w holes in factory console Replace rear cup holders ...