2 of 4
A
SSEMBLY
Carefully remove the contents from the carton and keep the carton for future storage. Be sure to untangle any wires
that may be tangled with other items. (Please DO NOT forcibly remove any contents.)
Step 1:
Locate the Tree Pot and place it where you are going to set up the tree – ensure that it is on a level surface and
near a dedicated power source.
THIS PRODUCT IS SUITABLE FOR INDOOR AND OUTDOOR USE.
Step 2:
Locate the Tree Bottom Section “A” which is tagged with the letter “A”. Remove any plastic protective pole cap
that is on the bottom of the pole (it can be saved and reused for storage if desired). Insert Tree Section “A” into the
Tree Pot. Do not force the pole. It will slide down to its correct position. Make sure the pole is firmly seated and
standing straight.
Step 3:
Locate Tree Top Section “B” which is tagged with the letter “B”. Insert it into the top of Tree Section “A”.
Step 4:
Connect the plug(s) from each tree section into the section below securely. The light sets each have a male
and/or female end connection with “Please plug in here” tags, so that you can find the corresponding connection
easier. Once all the light sets are connected in the tree, locate the pre-connected power adapter and insert it into a
120-volt power outlet in your home or into a UL approved extension cord or power strip (not included). The tree
should now be lit. If some bulbs do not light, please go to the
TROUBLESHOOTING GUIDE FOR LIGHT SETS
for steps.
S
HAPING
1.
Plug in the lights as you are shaping the tree. It is easier to see how the tree looks.
2.
Remove any packing strap or other packing material that is around the tree section(s) and allow the branches to fall
into place.
3.
Shape by section and layer, starting at the bottom of the tree and working your way up to ensure all branches are
shaped.
4.
Slowly pull down each branch to an approximate 90° angle to the floor on the lower sections and about a 45° angle
on the upper sections. While doing so, shape the tips on each individual branch by fanning out the tips to fill any
spaces. Offset the branches from one another to hide the tree’s pole and fill spaces. Continue spreading the tips
until they resemble that of a real tree.
5.
After shaping the whole tree, step back and take an overall look. Shift branches to fill any gaps. Your tree is now
ready to decorate and enjoy!
C
LEANING
&
C
ARE
As you will be using the artificial Christmas tree every year, it is essential to keep it in good condition and clean.
Dust gently using a soft cloth or fabric duster.
Do NOT use any chemicals or solvents to clean.
Handle the light sets gently. Do NOT pull or tug light sets as this may inadvertently loosen the bulb.
Follow all Storage and Safety Instructions.
S
TORAGE
1.
Unplug the tree from the power source in your home and disconnect the plug connection between the tree
sections.
2.
Remove any ornaments and decorations that were added by you and did not come with the tree.
3.
After the tree is used outdoors, allow the tree to dry thoroughly prior to packing.
4.
Starting with the top, separate each tree section and pot gently, being sure not to roughly handle as it could
cause damage to the parts and could loosen or break bulbs.
5.
Compress each tree section by turning it upside down and squeezing the branches together so that it will fit
more easily into the storage box or container. You can also tie a ribbon or cord around the sections to secure
the branches closer together for storage.
