READ THIS FIRST!!!
HAUSLER 450 SE V2 RTF (Ready-To-Fly)
Quick Start
Important Safety Notices
•
450 Size RC Helicopters use Lithium Polymer batteries (lipos).
•
DO NOT leave your batteries unattended while they are being charged.
•
You must have a fresh charge on your battery before you fly your 450.
Getting your HAUSLER 450 SE V2 RTF ready
Note: The manual shows an optional AC adapter for charging. All helicopters
come with a 12v charger so you can do a mobile charge from any 12V source.
Your transmitter is configured for Mode 2 – the cyclic is on the right stick, the
rudder and throttle on the left. RTF version comes with a 2.4 gHz digital six
channels radio system with Normal mode and one programmable flight mode for
full 3D/Stunt capability.
•
You need 8 AA batteries (not included) for the your transmitter
•
Remove the battery and the battery charger from the packaging.
•
The battery has two leads, a “T” plug and a balance plug with multiple colored
wires. Plug the balance plug into your charger and connect to a 12v source.
It is normal for the charger to be warm. Periodically remove the battery from
the charger during the charge to let the charger voltage readjust.
•
The three lights are red when the battery is discharged, and will go green
when the battery is fully charged. The charge rate is 1.2 amps, which will
take about 1 ½ hours to reach full charge.
•
You will get 5 – 6 minutes of flight time per charge. Do not try for longer flight
times as it can damage the battery.
Included Accessories
1. USB connection – transmitter to computer
2. Set up CD (for setting up flight modes)
3. Bind plug
4. Canopy grommets
5. Sticky tape and straps
6. Extra rubber stoppers for landing gear