Haulotte HA12CJ, Operator'S Manual

Page: 57 / 106

A
B
C
D
E
F
G
H
I
57 4000827180 E 09.18 USA / GB
C
- Pre-operation inspection
HA12CJ - HA32CJ - -
4.2 - A
CTIVATION OF CONTROLS
The deadman foot pedal (enable switch) must be activated to allow any movement.
The "Enable Switch" system depends on the machine configuration and will consist of one of
the following :
• Joystick trigger at platform box (if fitted).
• Foot pedal (enable switch) in the platform.
• Enable switch button at ground box.
4.3 - F
AULT DETECTOR
N.B.-:-T
HE PRESENCE OF THIS DEVICE DEPENDS ON THE MACHINE CONFIGURATION
.
The fault indicator LED flashes to indicate a malfunction.
The machine switches to downgraded mode.
Certain movements can be limited or forbidden to preserve the operator's safety.
4.3.1 - Buzzers test
F r o m t h e g r o u n d c o n t r o l b o x
4.4 - O
VERLOAD SENSING SYSTEM
If the platform load exceeds the maximum allowed load, no movement is possible from the 2
control boxes.
At ground and platform control boxes a buzzer sounds and an indicator light warns the
operator.
To return the machine to normal operation remove weight from the platform until the load is
below the maximum allowed load.
Daily check that the LED's illuminate when the machine is switched on :
• Verify that the Overload system is active : Refer to Indicators ( 6 ) at ground and ( 30 ) at
platform.
• Verify that the buzzers are functioning : Refer to Buzzers test
A periodic inspection of this device must be performed according to the recommendation in
Maintenance Schedule.
Step Action
1 Pull both E-Stop buttons ( 15 ) at ground box and ( 46 ) at platform box.
2
Select the ground control box or the platform control box by turning the control box activation
selector ( 72 ). The indicator ( 31 ) at the platform control box lights up, and there is an audible signal
(beep).