Haulotte HA100JRT, Operator'S Manual

Page: 71 / 122

A
B
C
D
E
F
G
H
I
71 4000328850 E 12 14 USA / GB
D
- Operation instructions
HA32PX - HA100JRT - HA41PX-NT - HA130JRT-NT
1.3 - O
PERATION FROM THE PLATFORM CONTROL BOX
• The platform control box can only be used if :
• The E-stop buttons on both ground and platform control boxes are not pressed in
(deactivated).
• Machine switched on at ground control box.
• Platform control box selected from ground control box.
• Overriding system not activated.
• A faulty joystick is not taken into account to control a movement. If this fault disappears, the
movement is authorised again.
• An E-stop button is present at each control box, it stops all movement and the engine (if
equipped). The E-stop button doesn't have function to turn off the power supply of the
machine.
• An "enable switch" ( 228 ) (foot pedal switch in the basket) is present and should be
activated to authorize one or more function movements. If the enable switch is kept active
for more than 8 seconds without selecting a function movement, then movement is
disallowed. The enable switch must be released (reset) before movement can occur.
• The release of "Enable switch" ( 228 ) while performing a movement stops all the
movements. The stop of movements is progressive. If the "Enable switch" is pressed again
quickly within 0,5 s the movement restarts. If the "Enable switch" is not pressed again
quickly enough within + 0,5 s the movement will not restart. It could restart only when the
selected function switch/joystick is released to neutral position.
• All switches and joystick operating a movement, return automatically to neutral when
released.
• At power up, a switch in it's neutral position will be taken into account to authorize movement.
• The status of the switches and joysticks is checked when the machine is switched on. A
switch or joystick is only considered validated after it is detected in neutral.
• A buzzer beeps in the following configurations :
• Check when power is switched on.
• Overload (if fitted).
• Slope if boom is out of the stowed position.
• Emergency pump : See dedicated paragraph
• Indicators - All the indicators are tested
• When the machine is switched on.
• When the combustion engine is started from the platform control box.