Haulotte Group HTL 3210, Operator'S Manual

Page: 203 / 248

203
2420344510 E 11.11 AUS
Telescopic handlers
H
- Lubrication and maintenance
11 - Every 100 h hours of operation
11.1 - TYRES
Criteria of replacement
Replace the hub and the tyres if any of the following conditions exist :
• Presence of cracks, damage, deformations or other faults on the hub.
• Damage on the tyre :
• A or hole > 3 cm (2 in) in the rubber side wall on the whole tyre thickness.
• Blister or pronounce lump on the external and lateral membrane.
• Damaged wheel stud.
• Damage or wear on the side wall to the extent that the reinforcing wire become visible.
• Check that the tyres are not damaged.
• Remove the valve cap.
• Add air if required.
• Replace the valve cap.
• Check the wheel lug nut torque (300 Nm).
N.B. -:-Perform the first torque check after the first 10 h of operation.
11.2 - DIESEL CIRCUIT
• Engine Perkins 1104D44T : Perform the first diesel pre-filter change after the first 500 hours of
operation and then after every 500 h or once a year ( Section H 15.2 -Diesel circuit).
11.3 - INTERNAL COMBUSTION ENGINE
• Perform the first engine oil drainage and change the filter cartridge after the first 500 hours of
operation and then every 500 h ( Section H 15.3 -Internal combustion engine).
For safety reasons, always use original HAULOTTE® spare parts that are specific to this machine. Refer
to the spare parts catalogue.
Check the tire inflation pressure : 4,5 bar(65 psi) minimum (For HAULOTTE® tyres, code : 2326014870 or
232601508).
During a pressure check or an inflation operation, always face the end of the tyre; never face the side of
the tyre